I am redoing some ATSF acts, and generated a Clovis WB act from
Belen to Muleshoe. Act sets up okay, and work order shows PU's and SO's
starting at Belen and working to Muleshoe, BUT when I started the act - the
train is at Muleshoe. That means I would have to run the entire track and
then turn around and work it back.. Is this correct, or is the train in the
wrong place at the outset? Your input will be appreciated.
Thanks Ted
smokeytc@295.ca
I have started the act since asking Steve this question, and am picking up all the PU's on the way to Belen. I will the leave them in Belen and pick up the SO's and work back. Seems awfully long and backwards to me. Any suggestions??
Am I wrong? I thought Belen to Muleshoe was Eastbound. Or did you mean Eastbound?
No -you are right - but when you make a Muleshoe West act it shows Belen to Muleshoe and then starts at Muleshoe, but the pickups are in Belen. Definitely backward. Would appreciate the author of the template commenting on this issue. Thanks Ted
Oh, okay. I misread what you said. So, if I understand, the switch list ( or work order ) is printing up in reverse. Hmmmm....
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)