Templates, Templates install Options

[zebsligh]

Hi guys, I need so expert help. My TS want reconice my templates. Clovis, Gallup Sub, NS and the list go on. I follow all the install instuctions and they still want show up when I start TS. However they are in the route folder. I do have what I think is the right files needed to run these acts. I have J Realmuto Friction 1.0, but I'm not sure if I have the right Physics V4.5 installed. I sure could use some help thanks, Zeb.

[zebsligh]

This is my route files, 3DTS_TEH2. atsfgp, atsfss, Cajon, D&H, E1, E2, J1, J2, KHPass2, LS&I, NiagaraCorridor, Sandpatch USA1, USA2, Willamette Pass. Did something go wrong on the install? I follow the readme to the letter. Are is the problem in my MSTS? I have nothing stored in TS. Thank again, Zeb.

[Ralph@Train-Puzz...]

This is my route files, 3DTS_TEH2. atsfgp, atsfss, Cajon, D&H, E1, E2, J1, J2, KHPass2, LS&I, NiagaraCorridor, Sandpatch USA1, USA2, Willamette Pass. Did something go wrong on the install? I follow the readme to the letter. Are is the problem in my MSTS? I have nothing stored in TS. Thank again, Zeb.

From your list, it appears that you have the following routes installed on your machine (in addition to the six default routes):

Tehachapi Pass 2 (3DTS_TEH2)
Glorieta Pass (atsfgp)
Seligman Sub (freeware) (atsfss)
Cajon Pass (payware) (Cajon)
Bridge Line (D&H)
Kicking Horse Pass 2 (KHPass2)
Lake Superior & Ishpeming (LS&I)
Niagara Corridor (NiagaraCorridor)
Sandpatch (Sandpatch)
Cascade Crossing (Willamette Pass)

You don't have the routes for the templates that you listed in your first post. You should try installing a template for one of the routes that you have, and see how that goes.