Converting switches & signals Options

[Old Geaser]

Well I must be doing something wrong. Every time I start making a new act, I click the Convert switches to manual and Convert signals to permissive.

I get the pop up saying something about switches have been changed. Same for signals. I seem to have no problem with some acts, but on the longer one where I do a little traveling, I cannot throw some switches, or get by the light.

Is there something else I have to do ? I am on one now on the revised East Metro, that has pu and so at CL LL Coal plant and I cannot get off the main at either end of the coal plant. Must be doing something wrong. Thanks

Bert

[Old Geaser]

Thanks Norm and Steve

I fecal better now that it has been explained to me. I had a problem at the same location on one of the original activities. I was not able to get off the main at the 1st entry. Was able to back in at the 2nd entry. I will try it again and if I cannot get in I will go on and make another, not using the coal plant.

Speaking of the Stevens Pass route, I live about 1\2 mile from the route here In Gold Bar, WA. I can see the trains in between the trees. We are in the Cascade Mt foothills, about 18 miles from the 8 mile tunnel. Thanks again

Bert