Printable Version of Topic
Click here to view this topic in its original format
Skyline User's Forum _ General MSTS Discussion _ ELECTRIC UNIT REFUSES TO MOVE
Posted by: Blue Train Nov 8 2010, 11:10 AM
Hi to ALL
Would like to know why a "train" will not move after installing a new route and trying to run one of the act created with the route.
But if I go into the MSTS ACT ED and change the player loco to one of MSTS default loco IE: the CLASS 50 then the the train "RUNS"
This could be a lot of things but I need to start somewhere to get it going again.
Thank you
Richard
Port Elizabeth
South Africa.
Posted by: smokeytc Nov 8 2010, 02:57 PM
QUOTE(Blue Train @ Nov 8 2010, 12:10 PM) 
Hi to ALL
Would like to know why a "train" will not move after installing a new route and trying to run one of the act created with the route.
But if I go into the MSTS ACT ED and change the player loco to one of MSTS default loco IE: the CLASS 50 then the the train "RUNS"
This could be a lot of things but I need to start somewhere to get it going again.
Thank you
Richard
Port Elizabeth
South Africa.
Would like to know why a "train" will not move after installing a new route and trying to run one of the act created with the route.
But if I go into the MSTS ACT ED and change the player loco to one of MSTS default loco IE: the CLASS 50 then the the train "RUNS"
This could be a lot of things but I need to start somewhere to get it going again.
Thank you
Richard
Port Elizabeth
South Africa.
Richard -I had the same problem - 1st time used the "P" key to put the Pantograph up (to touch the wires) and it worked.
2nd time that didn't work either and had to change engines. Hope this helps. Ted
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)